Barium Sulphate Vertical Mill2018-09-25

Summary:What are the faults and causes of the Barium Sulphate Vertical Mill? In the process of using the Barium Sulphate Vertical Mill, various failures may occur due to improper use. If it is not solved as soon as possible, it will greatly a…

Grinding Equipment Manufacturer

The PC Hammer Mill, MTW, MTM Medium Speed Trapezium Mill, Ball Mill and the LM, LUM Vertical Mill cover all requirements of crude, fine and ultrafine powder production in the industrial milling field. Production of free combination from 0 to 2500 meshes can be realized. No matter which industry you are in, chemistry, energy, construction material or metallurgy field, SBM will always meet all your demands.

Barium Sulphate Vertical Mill

Spare Parts Supply

SBM has a good many warehouses of spare parts. High-quality spare parts ensure safe and stable operation of equipment. Rapid transport by air removes worry about production interruption loss.

Providing accurate assessment of spare parts' consumption to ensure successful implementation of production plan. Rapid supply of high-quality spare parts to ensure continual operation of production lines so as to prevent loss.

Barium Sulphate Vertical Mill Detailed introduction

What are the faults and causes of the Barium Sulphate Vertical Mill?

In the process of using the Barium Sulphate Vertical Mill, various failures may occur due to improper use. If it is not solved as soon as possible, it will greatly affect the production efficiency. The following Shibang Industrial Technology Group introduces the Barium Sulphate Vertical Mill. Major failures and causes.

1. Fault: The sound of the grinding chamber of the Barium Sulphate Vertical Mill is abnormal, and the roller has a crashing sound on the grinding ring;

Reason: Milling cavity. After the machine is turned off, the grinding chamber is opened, and the roller is found to be rotated when the roller is turned, and the roller and the grinding ring are collapsed. The analysis is caused by poor lubrication of the roller bearings.

2. Fault: The roller and the grinding ring of the Barium Sulphate Vertical Mill are not properly worn. The surface of the roller is easily ground into a concave surface, and sometimes uneven and uneven stripes are found, and the grinding ring also has a concave grinding;

Reason: The suspension shaft oil chamber is connected to the air duct for wear. The reason is mainly caused by the continuous scouring of the powder in the grinding chamber.

3. Fault: The current of the Barium Sulphate Vertical Mill is too large. The suspension shaft components often fail to rotate and the current is too high;

Cause: Suspension component. After disintegration, the sliding bearing of the suspension shaft was found to be locked, and a large amount of sludge was present in the suspension shaft cavity. The reason is that the gap of the air outlet is too large, and the air pressure in the inner cavity of the suspension shaft is smaller than the air pressure in the grinding chamber, so that the dust enters the suspension shaft cavity.

The above is the main failure and cause of the Barium Sulphate Vertical Mill introduced by Shibang Industrial Technology Group. I hope to help you better use the Barium Sulphate Vertical Mill.

Why choose us

For complaints about production line operation from customers, we undertake to complete problem identification and solution offering within 24 hours, and solve the problem within 3/10 days for domestic/foreign customers.

Last:

Inquriy